Waveshare Platform Cable USB, Programmer & Debugger for Xilinx Devices

Product Description 

• Performance 
• Utilizing CY7C68013A+FPGA new hardware solution, compatible with the original XILINX Platform Cable USB and Platform Cable USB II
• Programs all Xilinx devices, including FPGAs / CPLDs / ISP Configuration PROMs
• Supports JTAG, Slave-Serial and SPI programming, to config all Xilinx devices
• Interfaces to devices operating at 5V / 3.3V / 2.5V / 1.8V / 1.5V
• Optional target clock frequency, supports XILINX software automatic frequency adjustment
• Firmware auto upgrade, it's possible to support more new released software and devices
• Anti-static and multi-layers signal isolation, to protect the target and the programmer itself
• Comes with adapter board and multi cables for easily connecting with official development board or other circuit boards
• Supported software
• Xilinx ISE
• iMPACT
• ChipScope
• Vivado
• Supported devices
• Xilinx FPGA devices: UltraScale / 7 series / Zynq / Kintex / Virtex / Artix / Spartan, etc.
• Xilinx CPLD devices: XC9500 / XC9500XL / XC9500XV / CoolRunner XPLA3 / CoolRunner-II, etc.
• Xilinx PROM devices: Platform Flash XCF00S / XCF00P / XL, etc.
• LED Status
• Red: USB connected
• Yellow: USB connected, and Vref (the target board) is powered
• How to Connect
• Connects to PC
• Via USB interface
• Connects to target board
• Platform Cable USB provides 3 different interfaces to connect with the target board: JTAG, Slave Serial, and SPI. The figure below shows the header pinouts of the interfaces: